Onkyo TX-SR606 - Manual (Page 41)

41
First Time Setup —Continued
The right surround back speaker has been detected
but the left surround back speaker hasn’t.
There is a problem with a speaker. The speaker may
be broken or the subwoofer may be emitting sound
that is too high.
The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Make sure speakers that cannot be detected are con-
nected properly.
Retry : Return to step 2 and try again.
Cancel : Cancel the automatic speaker setup.
❏ Write Error
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver is probably malfunctioning.
Contact your Onkyo dealer.
Retry : Return to step 2 and try again.
Cancel : Cancel the automatic speaker setup.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during
the automatic speaker setup, follow the directions on
pages 72–76.
Using a Powered Subwoofer
If you’re using a powered subwoofer, as it outputs very
low-frequency sound and its position is usually low down,
it may not be detected by the automatic speaker setup. In
this case, increase the subwoofer’s volume, select its
highest crossover frequency, and then try running the
automatic speaker setup again. Note that if the volume is
set too high and the sound distorts, it may not be detected,
so use an appropriate volume level. If the subwoofer has
a low-pass filter switch, set it to Off or Direct. Refer to
your subwoofer’s instruction manual for details.
Auto Speaker Setup
- - - - - Speaker Detect Error - - - - -
AUDYSSEY
Cancel
Retry
: Yes
: ---
:
: Yes
No
: Yes
: Yes
: Yes
: ---
FL
SL
SBL
C FR
SR
SBR
SW
Auto Speaker Setup
- - - - - Speaker Detect Error - - - - -
AUDYSSEY
Cancel
Retry
: Error
: Yes
: Yes
: Yes
: Yes
: Yes
: Yes
: Yes
FL
SL
SBL
C FR
SR
SBR
SW
Auto Speaker Setup
Speaker Detect Error
AUDYSSEY
Cancel
Retry
Auto Speaker Setup
Writing Error!
AUDYSSEY
Cancel
Retry
To Retry the Automatic Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be
detected are connected properly.