Miscellaneous setup, Advanced setup —continued – Onkyo TX-SR606 User Manual

Page 78

Advertising
background image

78

Advanced Setup

—Continued

This section explains items on the Miscellaneous menu.

Note:

• This procedure can also be performed on the AV

receiver by using its [SETUP], [ENTER], and arrow
buttons.

Volume Setup

Maximum Volume

With this setting, you can limit the maximum volume.
The Maximum Volume range is Off, 79 to 30.

Power On Volume

This setting determines what the volume will be each
time the AV receiver is turned on.
The range is Last, Min, 1 to 79, Max.
To use the same volume level as when the AV receiver
was last turned off, select Last.

Note:

• The Power On Volume setting cannot be set higher

than the Maximum Volume setting.

Headphone Level

With this setting, you can offset the headphone volume
relative to the main volume. This is useful if your head-
phones are too loud or too quiet at the volume setting you
usually use when listening through your speakers. The
headphone level can be set from –12 dB to +12 dB.

OSD Setup

Immediate Display

This setting determines whether operation details are
displayed onscreen immediately after an AV receiver
function is used.

On:

Displayed (default).

Off:

Not displayed.

Even if On is selected, operation details are not output if
the input source is connected to a COMPONENT
VIDEO IN or HDMI IN.

Monitor Type

With this setting, you can specify the aspect ratio of your
TV so that menus are displayed properly.

16:9:

Select if your TV is 16:9 (default).

4:3:

Select if your TV is 4:3.

Display Position

This setting determines where on the screen operation
details are displayed.

Bottom:

Bottom of the screen (default).

Top:

Top of the screen.

TV format

For the onscreen setup menus to display properly, you
must specify the TV system used in your area.

Auto:

Select this to have the AV receiver automati-
cally detect the TV system from the video input
signals.

NTSC:

Select if the TV system in your area is NTSC.

PAL:

Select if the TV system in your area is PAL.

Miscellaneous Setup

1

Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.

The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.

2

Use the Up and Down [

]/[

]

buttons to select
“6. Miscellaneous,” and then
press [ENTER].

3

Use the Up and Down [

]/[

]

buttons to select an item, and
then press [ENTER].

4

Use the Up and Down [

]/[

]

buttons to select an item, and
use the Left and Right [

]/[

]

buttons to change it.

The items are explained below.

5

When you’ve finished, press the
[SETUP] button.

Setup closes.

Advertising