Onkyo TX-SR606 - Manual (Page 50)

50
Common Functions —Continued
The following table shows the display indicator for each
digital signal format.
Normally, the AV receiver detects the format of digital
input signals automatically. However, if you experience
either of the following issues when playing PCM or DTS
sources, you can specify the signal format manually.
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or rewind-
ing a DTS CD, try the DTS setting.
Specifying the Digital Signal Format
Format Display
Dolby Digital
DTS
PCM
1 Press and hold the AV receiver’s
[DIGITAL INPUT] button for about
3 seconds.
2 While “Auto” is displayed (about
3 seconds), press the [DIGITAL
INPUT] button repeatedly to
select: PCM, DTS, or Auto.
PCM: Only 2-channel PCM format
input signals will be heard. If
the input signal is not PCM,
the PCM indicator will flash
and there will be no sound.
DTS: Only DTS (but not DTS-HD)
format input signals will be
heard. If the input signal is not
DTS, the DTS indicator will
flash and there will be no
sound.
Auto (default): The format is
detected automatically. If no
digital input signal is present,
the corresponding analog input
is used instead.
PCM
ON/STANDBY
ZONE 2 ZONE 2 LEVEL TONE MOVIE/TV MUSIC GAME DISPLAY RT/PTY/TP MEMORY
CLEAR
DIGITAL INPUT TUNING MODE OFF
PHONES
MULTI CH DVD VCR/DVR CBL/SAT GAME/TV AUX TAPE TUNER CD SETUP
SETUP MIC VIDEO L AUDIO R AUX INPUT
ENTER RETURN
TUNING PRESET
MASTER VOLUME
AV RECEIVER TX-SR606
STANDBY ZONE 2
PURE AUDIO
DIGITAL INPUT
DIGITAL INPUT
DIGITAL INPUT