Optimus CD-8400 - Manual (Page 11)

11
Special Features
Quickly Selecting Tracks When the CD changer is stopped or paused, press or (or
or on the remote control) until the CD changer displays the desired track’s
number. Or, enter the track number using the remote control’s number buttons,
then press
TRACK SET within 5 seconds.
If you use this feature while a CD plays, the CD changer stops playing the cur-
rent track and skips to the next or previous track.
Searching for a Section
of a Track To rapidly search forward or backward for a track section while a CD plays, hold
down
or on the front panel ( or on the remote control).
The display shows the elapsed time to help you locate the desired section, and
the CD plays at a lower volume and higher speed than normal. Release the but-
ton to resume normal play.
You can also search a track when a CD is paused. The searching speed is
faster, the display shows only the minutes, and you do not hear the CD play.
Note: You cannot search past the end ( End appears on the display) or the
beginning of a CD.
Assigning CDs to a
Custom CD Group You can assign any loaded CD into a custom CD group. This lets you group
your favorite CDs together for more convenient playback.
Follow these steps to assign CDs to a group.
1. While the CD changer is stopped, repeatedly press MODE until CUSTOM
and the number of the desired group light. (If any discs have been
assigned to the group, the lowest disc number appears on the display.
Press
CLEAR to clear the group.)
2. Select a CD for storing into the group.
• If you use DISC NUMBER , simply wait until the display blinks. The
disc number is automatically stored in memory.
• If you use the remote control’s number buttons, press DISC SET to
store the disc number in memory.
3. Repeat Step 2 to store all the CDs you want.
Notes:
• The custom group memory is kept even after you turn off the CD changer.
• The changer keeps the CDs stored in custom group memory for up to 2
days in the event of a power loss.
Checking the Custom Group Contents
With the CD changer stopped, repeatedly press MODE so CUSTOM and the
number of the desired group light. Then repeatedly press TIME so C and the
custom group number appear on the display. Then repeatedly press DISC
NUMBER . The programmed disc numbers appear in order as you press DISC
NUMBER .
Note: To change the CDs assigned to
a custom CD group, you must clear all
the entries and enter the desired CDs
again.