Optimus CD-8400 - Manual (Page 14)

14
Special Features
To cancel random play and continue normal play, select a disc other than the
one currently playing, either by pressing
DISC NUMBER or by using the
remote control’s number buttons, then pressing DISC SET . To stop random play,
press .
Notes:
• During play, press RANDOM to skip the track currently playing and
advance to the next random selection.
• You can switch between the ALL or SINGLE modes during random play.
• If the CD changer does not have 100 CDs loaded, the CD changer might
select the same track or CD more than once.
• You can use repeat during random play.
• If you start random play during programmed play, the program’s contents
are erased and the CD changer starts ALL random play.
Programming a Sequence You can program up to 36 selections from all loaded CDs to play in any order
you choose. A selection can be a single track or an entire CD.
Follow these steps to program a sequence.
1. Press to cancel the current function.
2. Press PGM on the remote control (or PROGRAM on the front panel). PGM
appears on the display.
3. Select the CD that contains the first track you want to program using the
remote control’s number buttons and DISC SET . The selected CD’s num-
ber and AL appear.
You can also use DISC NUMBER (or DISC on the remote) and
press PGM to select a CD. The disc number and AL appear. If you do not
select a track within about 2 seconds, the entire CD is automatically
stored.
If you program an entire CD, skip to Step 5.
4. Select the track you want to program using the remote control’s number
buttons and TRACK SET . The displayed track and disc numbers are stored
in the first memory position.
You can also use or then press PGM (or PROGRAM ) to select a
track.
5. Repeat Steps 3 and 4 for each track or CD you want to program, up to 36
selections.
6. Press / . The CD changer plays the sequence.
Notes:
• If you try to program a non-existent CD or track (for example track 10
when that CD has only nine tracks), the CD changer ignores the entry.
• Press or to move forward or backward through the pro-
grammed sequence while the sequence plays.
After the CD changer plays the last track in the programmed sequence, it stops,
but the programmed sequence is still in memory. Press
PGM then to restart
programmed play.
To clear the sequence, see “Clearing a Programmed Sequence” on Page 15.