Olympus 5060 - Manual (Page 17)

Replacing ROC Housing battery
ROC will indicate a low battery status by flashing a slow red Status LED.
1. Replacement battery type is CR2450 and can be found at most camera stores.
2. When installing the battery follow the + and - battery orientation on the circuit board.
ROC will retain the most recent strobe profile programmed even when the battery has
been removed (Refer fig 31).
Moisture Alarm
The Tetra 5060’s moisture alarm gives a visual indication that water has been detected
inside of the housing (Refer fig 32).
The two metal contacts at the bottom right of the ROC board in the Tetra Rear Plate
are the sensing contacts that react to water (Fig. 32). If water touches these contacts the
ROC LED panel will display an array of lights.
The moisture alarm will continue its display of lights until it no longer detects water and
continue the display for 5 additional minutes.To terminate the alarm , clear the contacts
of moisture and press the “+” button for three seconds.
18
(Fig. 31) (Fig. 32)