Olympus 5060 - Manual (Page 19)

20
Installing Classic Light (Optional)
Attach the battery pod to the bracket.
1)
Slide the raised pod detail through the T shaped channel of the bracket.
2) Tighten the two set screws using the supplied allen key.
Mounting the bracket to the Tetra.
1)
Remove the black nylon tips from the bracket using a phillips head screw driver.
2) Loosely center the bracket on the bottom of the Tetra.
3) Orient the long slot of the bracket over the tripod mount of the Tetra.
4) Place the split washer onto the screw.
5) Place the flat washer onto the screw.
6) Place screw and washers onto the bottom of the bracket so the screw passes through
the bracket and aligns with the tripod mount of the Tetra.
7) Tighten the screw with the supplied allen key.
Mounting the base piece to the Tetra.
1)
Place the base piece over the mounting details of the housing.
2) Insert the flat head screw through the base piece and tighten using the supplied allen key.
Attach the light arm to arm base by pressing FIRMLY until arm snaps into place.
Align top of arm with light head base and press FIRMLY together.Arm will snap into position.
To remove light head from arm,“break” the arm at the upper most joint. Apply pressure on the
light arm and not the light head. Do not apply pressure to the light head base. Doing so may
cause the base to break from the light head damaging the system.
Installing the Tetra Pointer Light (Optional)
1. Identify the appropriate parts in the Tetra Pointer Light Kit.
2. Kit includes the following (Refer fig. 37).
Hex screw, 1/4” base piece, Infinity arm, modeling light and light bracket.
3. Position the base piece details on the detail of the Tetra’s accessory hole.
4. Place the hex screw through the base piece and tighten with hex key.
5. Place Infinity arm with holder over the base piece and press firmly down until the Infinity
arm snaps into position (Refer fig. 38).