Olympus 5060 - Manual (Page 21)

22
Lens Installation and Removal
To remove the flat port
1. Slide locking pin away from lens (Refer fig. 39)
2. Rotate optic counter clockwise.
3. Pull away from housing.
To install the flat port
1. Perform an o-ring inspection.
2. Align lens to housing details.
3. Press lens into housing.
4. Rotate clockwise until locking pin engages.
Installing the wide angle lens
1. Perform an o-ring inspection.
2. Align the red dot beside the arrow indicator with the machined circle on the Tetra and
press the lens into the housing. The lens should be seated evenly around the sealing
surface.
3. Rotate the lens in the direction of the arrow, clock-wise.
4. Rotate the lens until the locking pin engages the detail and locks the lens onto the
housing. The red dot next to the words Light & Motion should now be aligned to the
machined detail on the Tetra housing.
Installing the wetmate macro lens
1. Orient the housing so the it is facing upwards or towards the surface of the water.
2. Place the macro lens onto the top of the flat port.
3. Gently rotate the macro lens clockwise. When the threads align, the macro lens will
thread into the flat port properly.