Olympus 5060 - Manual (Page 9)

Installing Bulkheads
1. Remove bulkhead cap by inserting a coin into the slot in the cap and turning counter-
clock wise (Refer fig. 13).
2. Check the O-ring and sealing surface of new bulkhead.
3. Insert the wires of the new bulkhead through the opening of the Tetra
(Refer fig. 14).
4. Seat the bulkhead onto the housing and turn clockwise to hand tighten.
5. Tighten the bulkhead with a 3/4” wrench.
6. Connect the bulkhead wire plug, now on the inside of the Tetra, to the white connector
on the ROC board (Refer fig 15).
7. Flatten bulkhead wires inside against the top of the Tetra to insure the wires don’t
interfere with the camera (Refer fig. 16).
Attaching Sync Cables to the Tetra
Nikonos Style
1. Align the index mark on the sync cord with the guide mark on the Tetra bulkhead. Push
the sync cord into the bulkhead connector.
2. Turn the threaded connector until it is seated firmly into the bulkhead.
3. If the sync cable has a locking ring, turn the locking ring until it is hand tight and has
secured the sync cable.
Wetlink Style
1. Apply silicon grease to Wetlink sync cable contacts.
1. Align all five pins of the Wetlink Sync cable with the five pin receptor of the bulkhead.
2. Push firmly until the pins are firmly seated in the bulkhead.
Wetmate sync cords and bulkheads are designed to be impervious to water. To ensure
long-term performance, flush with fresh water and dry contacts if exposed to salt water.
10