Opticon LH2 - Manual (Page 11)

Chapter 1
10
Chapter 1
11
• Click on the ASCII Setup button. In the ASCII Setup screen, select Echo typed
locally so that any keyboard commands you input will appear on your screen. Click
OK. This returns you to the Properties Setting. Click OK
2) Your PC and the imager should now communicate.
3) To verify that the imager and the PC are communicating properly, send the following
command from your PC keyboard to receive a response from the imager.
Send these commands and at the end of the command send a carriage return.
( <┘ represents a carriage return)
;>PA7 <┘
I <┘
Note: Be sure to use capital letters, e.g. “I”, not “i”.
4) The LH2 will send back the firmware version of the Imager.
Example:
Xap/i2232223006000010002363A06 sd+sq
5) Send the following command to turn OFF the serial command mode.
PA8 <┘
This Quick Start-Up procedure will get you started. However, to best understand the full
capabilities of this imager, you should read the complete manual.