Opticon LH2 - Manual (Page 78)

Hardware Settings
78
Hardware Settings
79
Command Name: Laser Targeting
Usage: Sets the targeting laser beam.
Description: This command allows you to turn ON or OFF the laser targeting
beam. The laser targeting beam is extremely help full to set the
imager during the initial set up. You can easily read a bar code by
pointing the laser dot in the center of the bar code.
Default: Laser aiming dot is turned ON.
Programming Code: Serial Command:
Laser ON (Default) P%0f1<┘
Options:
Programming Code:
Serial Command:
Laser OFF P%0f0<┘