Oricom W1 - Manual (Page 7)

7
Basic steps to install
This phone is not fully weather-sealed or waterproof. Its special
construction provides protection against splashes and dripping water.
Any water or liquid exposure other than the above may result in serious
damage to the phone. THE BASE AND CHARGE POD ARE NOT
WATER RESISTANT. ALWAYS WIPE DRY A DIRTY OR WET
HANDSET BEFOR PUTTING IN CHARGE BASE.
1. Connect the output plug of the
mains adaptor to the adaptor
socket on the back of the base unit
and the mains adaptor to the wall
mains supply.
2. Connect the telephone lead to the
phone cord socket on the back of
the base unit and to the wall
phone socket.
3. Insert 2AAA Ni-MH rechargeable
batteries (supplied) into each
handset, observing the correct
polarity, into the battery
compartment on the handset.
(Figure 1)
4. Before placing the battery door
back on the handset, make sure
there is no foreign matter under
the rubber seal located on the
under side.
5. Place the battery door back into
place and tighten the 2 screws
provided. (Figure 2)
6. Place the handset on the base unit
and let the batteries charge for a
full 14 hours before using.
7. To attach belt clip Turn the
handset over. Align the belt clip
with the holes on the both sides of
the handset. Press into place
Figure 1
Figure 2