Oricom W1 User Manual

Page 8

Advertising
background image




8

Wall mounting the base and charger

1. Turn the base over.
2. Attach the mounting bracket to the base as indicated.












3.

The phone base units are suitable for wall mounting. Use two screws

(not supplied) for fixing. Drill two holes horizontally side by side, 64mm
apart for main base and 48mm for charger. Leave the screws protruding
from the wall by 5mm. Now place the base over the screws and push
gently downwards. If base seems loose remove the base and tighten
screws a little, refit the base.


Use only the mains adaptor supplied with this Phone. Incorrect adaptor
polarity or voltage can seriously damage the unit.

BASE (MODELS060040D25)
Input: 240 VAC 50 Hz
Output: 6 VDC 400 mA

CHARGING POD (MODEL SO60015D22)
Input: 240 VAC 50 Hz
Output: 6 VDC 150 mA

Charging the handset

An empty battery icon indicates the batteries need recharging. Place
the handset on the base cradle to recharge the batteries. You should
hear a parking tone (double beep) when handset is put on the charging

cradle. The handset battery icon

scrolls during charging. Handset

may take some time to power up and it may get warm during initial

64mm

48mm

Base

Charger

Advertising