Usage, En 26, Digital time switch clock logic control – Kaiser EM3200 User Manual
Page 26
EN
26
4OO
2O:OO
I6O
Watt
°
c
Gramm
Min
6
OO
I5:34
I6O
Watt
°
c
Gramm
Min
4OO
2O:OO
I6O
Watt
°
c
Gramm
Min
6
OO
I5:34
I6O
Watt
°
c
Gramm
Min
3 4
1
1
2
2
6
5
USAGE
DIGITAL TIME SWITCH CLOCK LOGIC
CONTROL
Setting the clock
Initial mode
Initial mode
energy-saving mode
Energy-Saving mode
energy-saving mode
energy-saving mode
After your microwave oven is first plugged in or after a
power failure, the clock will flash to indicate that the time
is not correct.
•
Touch the display
or the indicator .
•
Touch the keys
and
to set the hours.
•
Touch again the display 1 or the indicator
to set
the minutes.
The minute numbers will start to flash.
•
Touch keys
and
to set the minutes.
•
To finish, touch the display
or the indicator
again.
To reset the time:
•
Touch the Clock-setting key
again for
second
till sound signal.
•
Repeat the forenamed actions.
If any function has been chosen, but not started by
touching the Start button , this function is cancelled in
60 seconds.
The digital time switch clock passes in the
,
thus burn buttons of working functions, the display
,
the indicator , buttons
and
.
If the device is in the Initial mode more than 60 seconds
it passes in the
.
If no function has been chosen for 60 seconds, the
device turns into a
: function
selection keys turn down, only display 1, clock indicator
, buttons
and
.
You can also enable / disable the
manually:
•
Tap and hold display
or indicator
for about 3
seconds.
The device is produced by the factory with the activated
energy-saving mode.
To set the current time:
The display
and indicator
begin to flash to show that
you are in clock setting mode.
1
2
2
3
4
2
3
4
1
2
1
5
1
2
Start 5
Stop 6
2
Start 5
Stop 6
1
2
1
1