Olicom 2 - Manual (Page 15)

SY-P4I865PE Lite DRAGON 2 Quick Start Guide
15
Har
dw
ar
e
Install
atio
n
This motherboard only support 1.5V AGP card (4X/8X card). If 3.3V AGP card is
used, the system will not boot-up and the AGPDET LED will lit.
CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to
clear the CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This
jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing of new data into the CMOS memory.
CMOS Clearing Clear CMOS Data Retain CMOS Data
JP5 Setting
Short pin 2-3 for
at least 5 seconds to
clear the CMOS
Short pin 1-2 to
retain new
settings
Note: You must unplug the power cable from the ATX power supply when
performing the CMOS Clear operation.
1 2 3 1 2 3
AGP Slot
If use 3.3V AGP c a rd,the system will no t p ower on a nd the AGPDET LED will lit.
(1.5V only)
(When AGPDET LED lit, it m eans 3.3V AGP c ard is used.)