Olicom 2 - Manual (Page 30)

SY-P4I865PE Lite DRAGON 2 Quick Start Guide
30
After flashing the BIOS, my system will not boot-up.
1. Try clearing the CMOS ram.
2. The BIOS chip is defective due to an unsuccessful flash, contact your nearest SOYO
branch for re-flashing.
Is there a way to reprogram my BIOS after an unsuccessful flash?
No other way, you need to send back the BIOS ROM to your nearest SOYO branch for re-flashing.
I’m using a 400 or 533 MHz FSB CPU, I cannot find the DDR 200MHz option in the
BIOS, why?
An 800 MHz CPU should be used if you want your memory to run at DDR 400 (PC3200).
VGA Issue
I cannot set my VGA to go higher than 16 color (640x 480).
1. Make sure that you have installed the Intel Inf driver.
2.
Install/ re-install the VGA driver.
After wake-up from Suspend to RAM or Standby mode, the screen has no display
but I can hear the hard disk operating
1. Check the VGA card manufacturer for a driver update, or make sure the VGA card
supports the Suspend to Ram function.
Audio Issue
How can I disable the on-board Audio?
Go to the SOYO Combo Feature menu in the BIOS setup, then set the “onboard audio” to disable.
I cannot get the sound working on my system.
1. Check if the speaker wire is connected to the line out connector on the M/B.
2. Check if the speaker is powered on.
3. Install the audio driver supplied on our driver disc.
4. Check BIOS setup if “onboard audio” is enabled.
5.
If sound is already installed, check our website for an audio driver update.