Onkyo DR-2000 - Manual (Page 18)

18
Speaker Setup
Setting up the speaker configuration using Smart Configuration
DVD/CD VIDEO 1 VIDEO 2 TV/LINE TAPE/MD AM VOLUME
INPUT
FM
TUNER PRESET
TUNING SPEAKER A/B TEST TONE DISTANCE CH SEL Theater-Dimensional
SETUP
Theater-Dimensional
DOWN UP SUBWOOFER
MODE
FM MODE PRESET MEORY DISPLAY SPEAKER SETUP
SURROUND STEREO ACOUSTIC CONTROL
STANDBY/ON ON
STANDBY
POWER
PHONES
OFF ON
INPUT SELECTOR
MODE
AU DIO
DVD
TV
TA/MD
LIS TEN ING MODE
A.C TR L
T – D STER EO
SU RR
TIT LE MEN U
SET UP
TV/V CR
RET URN
CH
TUN VOL ENTER
REPEAT MUTING
A – B
REC
DIMMER
OPEN/CLOSE
RANDOM SLOW
SUBTITLE – ON / OFF ANGLE ZOOM
MEMORY CLEAR AUDIO DISPLAY
-- / ---
SW MODE
LATE NIGHT DISTANCE
CH SEL
T– D SETUP UP/ DOWN
TEST TONE
SP A
SP B
1 2 3
4 5 6
7 8 9
+10 0 SEARCH
STNBY ON
SLE EP
PHONES
OFF ON OFF ON Press the lower
part of the cover
to open.
AU
DIO
Before operating the
remote controller
Press MODE AUDIO.
The remote controller
remains in the AUDIO mode
until another MODE button is
pressed.
1 2
3
Unit only
SPEAKER SETUP DOWN UP
UP/ DOWN
9
SEARCH
Display
Subwoofer field
Surround left and
right speaker field
Center speaker field
Front left and right speaker field
Unit
Remote controller
Press DOWN/UP on the unit or
UP /DOWN on the remote
controller to enter the speaker
identification number.
Find the speaker identification number in
the tables on the previous page.
Notes
• If no speaker is connected, select “0.”
(There is no “0” setting for the front left and
right speakers since they must be connected.)
• If any speaker other than the speakers listed
in the table is connected, select “9.”
Press CH SEL to select the next
field.
Repeat steps 2 and 3 until you finish the
subwoofer field.
Smart Configuration is complete when the
subwoofer field is set.
Press SPEAKER SETUP.
“SmartConfig” appears in the display, then
“SP- ” appears shortly after.
Note
If any display appears other than “SmartConfig,”
press the button repeatedly until “SmartConfig”
appears.
Each “ ” is the field to enter the speaker
identification number.
The flashing field is currently selected.
8
CH SEL
CH SEL
Unit
Remote controller
Tips
• If a speaker field is set to “9,” adjust its volume balance manually.
See “Adjusting Each Speaker's Relative Volume Balance – Test
Tone” on page 21.
• For precise setting, carry out “Setting the Distance From the
Listening Position to Each Speaker” on page 20.
2 3 1
3
2