Onkyo DR-2000 - Manual (Page 19)

19
Setting up Non-Onkyo Speakers
INPUT SELECTOR
MODE
AU DIO
DVD
TV
TA/MD
LIS TEN ING MODE
A.C TR L
T – D STER EO
SU RR
TIT LE MEN U
SET UP
TV/V CR
RET URN
CH
TUN VOL ENTER
REPEAT MUTING
A – B
REC
DIMMER
OPEN/CLOSE
RANDOM SLOW
SUBTITLE – ON / OFF ANGLE ZOOM
MEMORY CLEAR AUDIO DISPLAY
-- / ---
SW MODE
LATE NIGHT DISTANCE
CH SEL
T– D SETUP UP/ DOWN
TEST TONE
SP A
SP B
1 2 3
4 5 6
7 8 9
+10 0 SEARCH
STNBY ON
SLE EP
AU
DIO
Unit
Remote controller
→
Setting the Subwoofer Mode
Press SUBWOOFER MODE on the
unit or SW MODE on the remote
controller.
With the first press of the button, you can
check the present setting. Then each press
of the button changes the subwoofer mode
as follows (a tip on how to select the right
subwoofer mode is in parentheses):
SW Mode 2
(When large–wideband–front speakers
are connected)
↓
SW Off
(When no subwoofer is connected)
↓
SW Mode 1
(When small–with limited bass signal
handling–front speakers are
connected)
The normal display resumes in three
seconds.
SW MODE
→
Selecting the number of speaker channels
Press SPEAKER SETUP repeatedly
to select the number of channels
for the SPEAKERS A system.
Although “SmartConfig” may appear in the
display, do not select “SmartConfig” in this
step.
Within three seconds, press the button
repeatedly. The number of channels
changes as follows (the corresponding
speaker configuration is described in
parentheses):
SmartConfig
Do not select this in this step. If “SP-
” appears, you can move to the next
setting by pressing SPEAKER SETUP.
↓
Speaker 2 ch
(Front left and right speakers)
↓
Speaker 3 ch
(Front left, center, and right speakers)
↓
Speaker 4 ch
(Front left and right, plus surround left
and right speakers)
↓
Speaker 5 ch
(Front left, center, and right, plus
surround left and right speakers)
The normal display resumes in three
seconds.
Notes
• The listening mode will automatically be set to
“Stereo” (see page 38) once you set or reset
the number of channels.
• To check the present setting while the normal
display is displayed, press SPEAKER SETUP
once. To change the setting, press the button
repeatedly within three seconds.
Unit only
SPEAKER SETUP
DVD/CD VIDEO 1 VIDEO 2 TV/LINE TAPE/MD AM VOLUME
INPUT
FM
TUNER PRESET
TUNING SPEAKER A/B TEST TONE DISTANCE CH SEL Theater-Dimensional SETUP
Theater-Dimensional
DOWN UP SUBWOOFER MODE FM MODE PRESET MEORY DISPLAY SPEAKER SETUP
SURROUND STEREO ACOUSTIC CONTROL
STANDBY/ON ON
STANDBY
POWER
PHONES
OFF ON
SUBWOOFER
MODE SPEAKER
SETUP
SUBWOOFER
MODE
SW MODE
1
PHONES
OFF ON OFF ON
Display
Press the lower
part of the cover
to open.
Before operating the
remote controller
Press MODE AUDIO.
The remote controller
remains in the AUDIO mode
until another MODE button is
pressed.