Optiview TRKPTZ -26NX - Manual (Page 34)

Auto Zooming Tracking Dome Camera User Manual
33
(2) Move the joystick up or down to view selections. Press
iris Open to confirm selection.
(3) Move joystick to position the cursor beside PROGRAM
PATTERN.
(4) Press iris Open.
(5) Follow the directions displayed on the monitor.
After a pattern is programmed, the remaining storage
percentage will be displayed on the screen. This is the amount of
memory available to program the remaining patterns.
CLEAR PATTERN:
(1) Move joystick to position the cursor beside CLEAR
PATTERN.
(2). Press iris Open.
(3) F0llow the directions displayed on the monitor.
3.5.7 Zone Setting
Move joystick to select <ZONES>, then press Open to enter
the zones menu shown as Fig 3.14.
Figure 3.14 ZONES SETTING
ZONES
ZONE NUMBER 1
…
ZONE NOT DEFINEO
…
<EDIT ZONE LABEL>
<EDIT ZONE>
ZONE
ENABLED ON
<CLEAR ZONE >
BACK
EXIT