Olympus CAMEDIA E 10 - Manual (Page 93)

91
6
5
Press the button.
The green highlight returns to the flash
control mark
and the setting is stored.
When any value other than zero (0) is
selected, the flash control mark
is
displayed in the control panel. Please
remember that this setting is retained even
after the camera is switched off and
switched on again.
To release this setting, reset the value for
zero.
Press the button again to close the
menu.
6
Take the picture.
To use the dedicated external flash
and built-in flash together
When the dedicated external flash is mounted
on the camera, the camera automatically sets
the flash for TTL-AUTO. With this setting, the
camera can adjust the intensity of the flash fired
from the dedicated flash, just as it automatically
adjusts the flash intensity for the built-in flash. If
you set the dedicated flash for MANUAL, this
disables automatic adjustment of the flash
intensity only for the dedicated external flash;
the intensity of the built-in flash will continue to
be controlled by the camera.
5
Control panel
Displayed only when an
exposure value other
than 0 is selected.