Quantum Audio Travan 40 Tape Drive STT3401A - Manual (Page 22)

Chapter 4 Drive operation and maintenance
Page 14 Seagate Travan 40 Product Manual
6. Secure the drive using the mounting screws. The threaded mounting brackets
are designed for M3.0 metric screws. If you are mounting the drive in a 3.5-inch
bay, use the screw supplied with the drive. Do not substitute other screws. Using
longer screws may damage the drive. If slide rails are needed, use the plastic
slide rails (supplied with the drive in some configurations).
7. Connect an available power cable to the power connector on the drive. Figure 6
on page 12 shows the location of the power connector. The recommended
power mating connector should have an AMP 1-48024-0 housing with AMP
60617-1 pins or equivalent.
Note: Turn off all power before attaching power or interface connectors.
8. Connect the interface cable with the connector on the rear of the unit. When you
make the connection, be sure pin 1 of the connector aligns with pin 1 on the
cable connector. See Figure 6 on page 12 for the location of the connector and
the Pin 1 location.
Note: Pin 1 on the connector on the rear of the drive is to your right as you look at
the back of the drive (right side up). (See Figure 5.) Your cable should have
Pin 1 highlighted by a color or dark strip. Be sure to mate Pin 1 on the cable
to Pin 1 on the drive. Failure to do so could make the drive inoperative. Also,
the cable is keyed to prevent incorrect installation. Make sure that the
blocked pin in the cable connector coincides with the missing pin on the
connector on the rear of the drive. (See Figure 6.)
9. Replace the computer cover. Be sure to reconnect any peripherals that you
disconnected during the installation.
10. Plug the computer and any peripherals into an AC power outlet.
11. Start the computer and install your tape backup software.
Mounting dimensions
Figures 8 and 9, respectively, show the location of the mounting holes for the
STT3401A and STT2401A.