Appendix- ethernet cable pinouts – QSC Audio CM16a User Manual
Page 37
Advertising
![background image](/manuals/207015/37/background.png)
37
Section 6:
Appendix- Ethernet Cable Pinouts
A
crossover cable has the RX and TX wire pairs switched around at one end. There are only two likely situations that would require a
crossover cable: to connect a single system controller computer directly to a single CM16a device; and to cascade hubs that don’t have uplink
ports.
ETHERNET CABLING
This diagram shows the pinout for
standard unshielded twisted-pair (UTP) network cable. Both ends of the cable are wired
identically.
RJ-45 pinout for standard Ethernet
patch cable (both ends identical)
RJ-45 pinout for an Ethernet
crossover cable
RS-232 Null Modem Cable Pinout
Advertising