Quantum Audio Tape Library PX502 - Manual (Page 11)

PX502 Tape Library Quick Start Guide
11
• Figure 17 Native Fibre Channel System Controller
Board
Figure 15 PX502 Cable
Configuration (SCSI System
Controller Board)
Figure 16 PX502 Cable
Configuration (Surrogate)
N OTE : Quantum ships sufficient SCSI cables and
terminators with the libraries to set up two-drives
per SCSI bus. One tape drive per SCSI bus may be
necessary for optimum performance. Refer to
your tape drive documentation.
N OTE : SCSI cable lengths should not exceed:
• 39.37 feet (12 meters) between the host and
the library for single drive per bus installations.
N OTE : When operating in surrogate mode, the SCSI host
connection must be made to tape drive 1.
Back of Library
SCSI host Ethernet
Power
SCSI System Controller Board
Tape drive 1 Tape drive 2
Back of Library
SCSI host Ethernet
Power
Surrogate System
Controller Board
Tape drive 2 Tape drive 1
Figure 17 PX502 Cable
Configuration (Native Fibre
Channel)
2 Connect one end of an AC power cable to each
installed power supply and to a wall outlet.
Initial Configuration 0
Initially configuring the library consists of the following
steps:
•
Turning on the Library
• Removing the Remaining Packing Materials
• Setting the Library Options
• Setting the Date and Time
• Setting Network Information
Turning on the Library 0
To turn on the library:
1 Verify that:
• Power cables are firmly in place
• All doors are closed and latched
2 Turn on the library by pushing power button located on
the bottom left-hand corner of the OCP (see figure 18 ).
Back of Library
Fibre Channel
host/SAN Ethernet
Power
Tape drive 2 Tape drive 1
LTO Tape drives
shown. SDLT drives
have a single FC port
Fibre Channel
host/SAN Fibre Channel
host/SAN