Quadra-Fire 1100-I - Manual (Page 9)

POWER SUPPLY
1. The power can be connected from either the left or right side of the insert. First determine which side is closest to an
electrical outlet.
a) For power from the left, remove the left side panel and locate the power inlet (about 4” [100mm] up from the
floor of the insert (refer to drawings below)). Remove the cover plate and discard, plug the power supply cord in
and reinstall panel.
b) For power from the right, remove the right side panel. The power inlet is on the right side of the junction box,
directly under the thermostat call light and the reset button. Remove the cover plate and discard, plug the power
supply cord in, then be sure that you have connected the thermostat before reinstalling the side panel.
NOTE: Never install the power cord under the insert body or around sharp corners, and always maintain the
power cord’s integrity.
THERMOSTAT INSTALLATION
1. A 24-volt thermostat is required to operate this pellet insert. Some thermostats are equipped with an adjustable heat
anticipator. The amperage draw on this insert is .05 amps, so generally the lowest anticipator setting will work.
2. When mounting the thermostat on a wall, be sure to follow your thermostat installation instructions carefully. The
thermostat should be mounted on an inside wall and not in direct line with the insert’s convection air outlet.
NOTE: Be sure the thermostat is mounted level for accurate readings. If the thermostat is located too close to
the insert, you may need to set the temperature setting slightly higher to maintain the desired temperature in
your home.
3. To connect the thermostat wiring to the insert, you must first remove the right side panel using the 5/32 hex head wrench
provided, and remove the flush mounted screws on the far right side of the insert. The panel can now be lifted out of the
way.
4. There is a four screw terminal block located on the right hand side of the junction box, between the fuse receptacle and the
power cord inlet. The top and bottom screws are the mounting screws for the terminal block. The center two screws are
for the thermostat wires. Attach the red wire to the second screw from the top of the terminal block and the white wire to
the third screw from the top.
Page 9