Tricity Bendix SG211X - Manual (Page 11)

11
Using the Hob
The Hob Burners
The symbol on the control panel shows which
burner is operated by the knob. (See control
panel).
Off
Maximum level
Minimum level
Use the maximum level for boiling and the minimum
for simmering.
Always choose positions between the minimum
and maximum, never between maximum and off.
Ignition of the burners
• Push the knob and turn it left to the “large flame“
symbol.
• At the same time, push the electronic ignition
knob (see fig). Keep it pushed until the gas
ignites (1 spark / second).
• Release the knob and check that the burner
has ignited.
• Upon ignition, adjust the flame as required.
OR
Power Cut
• Push the corresponding knob in
completely and turn it left to the “large
flame“ symbol and ignite with a match.
• Release the knob and check that the
burner has ignited.
• Upon ignition, adjust the flame as required.
If for any reason the flame should extinguish
turn off the relevant control knob, leave for at
least one minute and then re-ignite.
If after a few attempts the burner does not
ignite, check that the burner ring and its cap
are correctly positioned.
Turning off the burners
Turn the control knob clockwise to mark « ».
Do not put anything on the hob that is
liable to melt.
Selecting the Correct burner
Above every knob there is a symbol for the
corresponding burner.
For good cooking results, always choose
pans, which correctly fit to the diameter of the
burner used (see figs). Choose thick, flat
bottom pots.
We recommend the flame is lowered as soon
as the liquid starts boiling.
Good use
Bad use
(Power waste)