Tricity Bendix SG211X - Manual (Page 20)

20
Advice for safety
Gas connections
• Before installation ensures that the local
distribution conditions (gas type and
pressure) and the pre-setting of the appliance
are consistent.
• This appliance must be installed only in a
room with good ventilation.
• This appliance must not connect to a
chimney. It has to be installed and connected
in accordance with the rules in force. Special
attention should be paid to the applicable
disposal concerning ventilation.
• The adjacent furniture panels have to be heat
proof or protected by such material.
• The adjusting conditions of this appliance are
mentioned on the rating plate.
Connection to gas supply.
Check that the gas flow and the diameter of the
supply pipe is sufficient to supply all the
appliances of the installation.
• Check that all connections are tight.
• Install an accessible and visible gas tap to
isolate the appliance.
The manufacturer declines any responsibility
for possible damages resulting from an
installation, which doesn't comply with
current legislation.
-
Installation of flues and ventilation for gas
appliances of rated input not exceeding 60
kW (1 st , 2 nd and 3 rd family gases) – Part 2
Specification for installation of ventilation for
gas appliances – BS 5440 Current editions;
-
Gas burning appliances – Part 3 Domestic
cooking appliances burning gas – BS 5386
Current editions;
- Specification for installation of low
pressure gas pipe work of up to 20mm
(R1) in domestic premises (2 nd family
gas) – BS 6891 Current editions;
-
Pipe threads for tubes and fittings where
pressure-tight joints are made on the
threads (metric dimensions) – BS 21
Current editions;
-
Flexible hoses, end fittings and sockets
for gas burning appliances – BS 669
Current editions;
-
Installation of domestic gas cooking
appliances (1 st , 2 nd and 3 rd family gases)
– BS 6172: 1990 Current editions;
For appliances installed in the Republic of
Ireland please refer to NSAI-Domestic Gas
Installation IS813 Current editions.
Electrical connections
Any electrical work required to install this
cooker should be carried out by a qualified
electrician or competent person, in
accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This cooker is designed to be connected to a
230-240V AC 50Hz electrical supply.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the cooker rating plate. The rating plate is
located on the oven frame.