Tricity Bendix TBG700 - Manual (Page 20)

20
Fitting the Hob into the Worktop
Carry out the building in of the hob as follows:
1. place the seals supplied with the hob on the front edge of the cut out. Then,
place them at 50 mm from the side edges and at 10 mm from the rear edge,
as shown in the diagram, taking
care that the seals meet without
overlapping.
2. Place the hob in the cut out, taking
care that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the injectors
kit (see diagram). When the screws
have been tightened, the excess
seal can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.
Seal