Toshiba A40 Series - Manual (Page 157)

7-5
HW S
ETUP
AND
P
ASSWORDS
Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
ECP Sets the port type to Extended Capabilities Port (ECP). For
most printers, the port should be set to ECP. (Default)
Standard This setting should be used with some other parallel
Bi-directional devices.
Display
This tab lets you customize your computer’s display settings for either the internal
LCD screen or for an external monitor.
Power On Display
Lets you use the display to be used when the computer is booted. (This setting is
only available on Standard VGA mode and not available on Windows Desktop)
Auto-Selected Selects an external monitor if one is connected. Other-
wise, it selects the internal LCD. (Default)
LCD + Analog RGB Selects both the internal LCD and external monitor for
simultaneous display.
CPU
Celeron models are not equipped with CPU tab.
This function lets you set the CPU operating mode.
Dynamic CPU Frequency Mode
This option lets you choose from the following settings:
Dynamically CPU power consumption and clock speed
Switchable automatic switching function is enabled. When
the computer is in use, CPU operation is
automatically switched when necessary. (Default)
Always High CPU power consumption and clock speed automatic
switching function is disabled. The CPU always runs
at its fastest speed.
Always Low CPU power consumption and clock speed automatic
switching function is disabled. The CPU always runs at
low power consumption and low speed.
HW Setup