Toshiba A40 Series - Manual (Page 160)

User's Manual
7-8
HW S
ETUP
AND
P
ASSWORDS
3. Use the left/right cursor keys to highlight the boot device you want and press
Enter.
NOTES: 1. If a supervisor password is set, the menu above does not
appear when you use the user password to start the
computer.
2. The selection method above does not change the boot
priority settings in HW Setup.
3. If you press a key other than one of those above or if the
selected device is not installed, the system will boot according
to the current setting in HW Setup.
4. Support of PC (ATA) card boot is guaranteed only for
TOSHIBA PC card HDDs.
5. A PC (ATA) card takes the position of HDD in the Boot
Priority Options list.
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set the
priority for HDD detection. If the first detected HDD has a boot command, the
system will boot from the HDD.
Built-in HDD
−> −> −> −> −>
PC Card (Default)
HDDs are searched for a boot command in the following
order: the built-in HDD, and the PC card. (Default)
PC Card
−> −> −> −> −>
Built-in HDD
HDDs are searched for a boot command in the following
order: the built-in HDD and the PC card.
NOTE: If a boot command is not found on the first detected HDD, the
system will not boot from the other HDD. It will search the next device in
the boot priority for a boot command.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]
Sets PXE as the protocol. (Default)
[RPL]
Sets RPL as the protocol.