Thermador T36IB70NSP - Manual (Page 25)

25
Function of different parts:
1. Double threaded bolt on the adjusting rail:
for vertical adjustment of the furniture door.
2. Side brackets:
for adjusting the depth of the furniture front.
3. Nuts on the double threaded bolt:
for securing the furniture front to prevent lateral
movement.
4. Lower brackets:
for securing the furniture front to prevent lateral
movement.
2 adjacent furniture doors can be attached instead of
one large door. These furniture doors must be
connected to a metal strip on the rear.
This metal strip can be purchased from customer
service as an optional accessory, see the section on
Optional accessories" on page 12.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and
the position of the drill holes. Always screw into the best
loadĆbearing material of the furniture door.
Never screw into fillers, decorative strips or similar.
19. Loading the appliance door
When attaching the furniture doors, it is recommended
to load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
Refrigerator compartment 55 lbs / 25 kg
Freezer compartment 22 lbs / 10 kg
20. Attaching the adjusting rail
to the furniture door
(refrigerator compartment)
i The adjusting rail is the most important means of
adjusting the furniture front.
q Unscrew the installation support part from the
appliance doors.
i Store the positioning aids, there will be used in
an installation step later.
q Remove the cover plate from the freezer
compartment door.
i Check the double threaded bolts on the adjusting
rail. Both of them must project out of the door by
3 /
16
" (5 mm).