Thermador MES301HS - Manual (Page 13)

13
The water tank is located on the right when you open the appliance door.
Use only fresh tap water or purchased nonĆcarbonated water to fill the water tank.
If your water is very hard, we recommend using softened water.
If the tap water is highly chlorinated (> 40 mg/l), use nonĆcarbonated mineral water
with a low amount of chlorine. Contact your water utility company to find out what
type of tap water you have.
Moisten the seal in the tank lid with some water prior to initial use.
CAUTION: Ą Do not fill the water tank with distilled water or any other
liquids.
Fill water tank before each use.
1. Fill the water tank with cold water up to the "max" mark.
2. Close the tank lid until it clearly snaps in place.
3. Slide in the water tank until it locks into position.
Empty the water tank after each use.
1. Keep the water tank level while slowly pulling it out of the appliance to ensure
that no remaining water drips down and out through the vent.
2. Pour out the water.
3. Thoroughly dry the seal of the tank lid and the slot where the tank resides in the
appliance.
The 9 display appears if you set the oven mode when the water tank is only half
full.
If you think that the amount of water in the water tank is sufficient for what you want
to cook, you can start the appliance.
If the water level is too low, then fill the water tank up to "max", slide the tank back in
and then start the appliance.
Water Tank
ř
Before Each Use
After Each Use
9 Appears