Service, Before calling service – Thermador MES301HS User Manual

Page 56

Advertising
background image

56

ā

Service

Before Calling Service

If a problem occurs, it is usually just minor. Read the following information before

calling customer service.
Repairs must be made by trained customer service technicians only. Improper

repairs made to the appliance can place you at extreme risk.

Problem

Possible cause

Tip / Solution

Appliance is not working

Cord is not plugged in

Connect appliance to power

Power outage

Check if other kitchen appliances are

working

Defective fuse

Check the fuse or breaker box to see if

the breaker or fuse to the appliance is

working

Faulty operation

Turn off power to the appliance at the

main power supply (fuse or breaker box)

and turn it back on after approximately

10 seconds

Appliance does not start

Appliance door is not closed all the way

Close the door

Appliance does not start,

‹‹:…‹ min. appears and < flashes

in the display

Steam Clean or Decalcify was canceled

Clean the appliance twice

(see Canceling Steam Clean or

Canceling Decalcify Mode)

Four zeros appear in the display ‹‹:‹‹

Power outage

Set the current time using the settings dial

and then press TIMER/CLOCK

Appliance is not operating. A cook time

appears in the display

The settings dial was turned accidentally

Press START/STOP

appears in the display

After adjusting the setting, START/STOP

was not pressed

Press START/STOP, or clear the setting

by pressing ON/OFF

Appliance is not heating up. Three heat

indicator bars appear in the display

A touchpad combination was pressed

Disconnect from power and reconnect

after approximately 20 seconds.

Within 2 minutes, press and hold PANEL

LOCK for 4 seconds

”‰ appears in the display

Automatic shutoff is activated

Press any touchpad

9

appears

Appliance has not been used for at least

2 days and the water tank is full

Empty and clean the water tank. Always

empty the water tank after cooking

The

9

indicator appears, but the water

tank is full

Water tank was not inserted correctly

Slide in water tank until it locks in place

tank is full

Detection system not working

Call customer service

Advertising
This manual is related to the following products: