Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 48)

ASSEMBLY
Assembly Section 2-16
SELECTOR VALVE INSTALLATION
NOTE: Refer to the parts section and illustration below for hardware and position.
The selector valve is attached to the boom rest. The 1/4” hoses from the swivel section of the
lift valve are plumbed to the “A” and “B” ports on the selector valve. A run tee is added to the
return section of the lift valve. Attach the 1/2” hose from the “T” port of the selector valve to the
run tee on the lift valve. 1/4” hoses are attached to the “A1”, ”A2”, “B1” & “B2” ports on the
selector valve to the knuckle cylinder and swivel cylider.
(ASM-SLCTR VLV INSTLN-0001)
FILLING HYDRAULIC RESERVOIR
Refer to the maintenance section for filling specifications and hydraulic oil requirements.
NOTE: Starting or running your Tiger mower before filling reservoir will cause
serious damage to hydraulic pump.
(ASM-C-0004hydro resrv)
SIDE HYDRAULIC TANK INSTALLATION
Install all fittings and tubes into tank and tank filter as shown in the Parts Section illustration.
Insert tank sight glass into front side of tank.
Place the tank in the mounting bracket on the main frame as shown in the Parts Section.
Secure the tank with the tank channel mount by placing the channel mount on top of the tank and
the washers over the holes. Thread the tie bolts through the washers and holes to the threaded
holes on the main frame. Tighten the tank channel mount by using the hex heads on the end of
the tie bolts.
Install the filter gauge into the filter housing so that it points to the rear of the tractor and is
clearly visible to the operator. The tank breather cap is ready for use as the tank is filled. Some
of the for-metioned items may be already installed.
(ASM-MOTOR HYDRO-0001)
GENERAL HOSE INSTALLATION
Refer to the parts section for detailed information about hoses and fittings for this application.
(ASM-C-0011)