Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 53)

ASSEMBLY
Assembly Section 2-21
RS AXLE BRACE MOUNTING
The rear stow axle braces are to be mounted under the rear axle of the tractor. The other
end of the axle brace mounts on the outside of the lower rear corners of the main frame. After
attaching the boom rest, it should fit tightly and level under the tractor. Attach the axle brace(s) to
the main frame with hardware shown in the Parts Section and tighten. Attach the axle braces to
the rear axle using the mounting hardware shown in the parts section, but DO NOT tighten.
RS BOOM REST MOUNTING
Carefully raise the rear stow boom rest and align the holes with those of the axle brace. Now
install all attaching hardware as shown in the parts section loosely, to allow for the alignment with
the left and right axle brace. Tighten / torque all hardware on the brace and the boom rest.
Finally, add the rest strips to the boom rest as shown in the Parts Section.
(ASM-JDBOOM-0001)
BOOM MOUNTING BRACKET
Using a floor jack and / or a hoist, raise the boom mounting bracket up to level and slide the
bracket into position onto main frame as shown in parts section.
Install pin through main frame and bracket. Secure with cap-screw, lock-washer and hex nut
through boss on main frame as shown.
Secure mounting bracket to main frame with the cap-screws, lock-washers, flat-washers, cut
flat-washers and hex nuts provided. Secure using the two slotted holes on the bracket and main
frame.
(ASM-C-0014)