Burner control knob bezels, Thermador® extralow burners (sgsx models only) – Thermador SGSX456 User Manual
Page 10
English 6
To operate: Select the appropriate control knob, push down and turn counter-
clockwise to the desired flame size. Turn OFF by turning the control knob clock-
wise to the •, indicating OFF.
Burner Control Knob Bezels
The bezels for standard burner controls feature one unnotched area on the under-
side. This single area snaps into the straight area in the cooktop so that OFF is at
the 12 o’clock position.
To remove knob and bezel: With burner in the OFF position, gently lift knob up
and off. Gently lift the bezel from the sides and pull up.
WARNING:
To avoid possible electric shock, do not reach through
bezel opening into rough-in box.
To replace bezel and knob: With the • on the bezel in the 12 o’clock position,
press to snap in place. Replace control knob by placing indicator line at the 12
o’clock position; press down firmly. For models SGSX only, be sure to replace
ExtraLow® bezels in the 2 left burner positions.
Thermador® ExtraLow Burners
(SGSX Models only)
Two burners are enhanced with the ExtraLow (XLO®) feature. When the control
knob is set within the XLO® zone, the flame cycles OFF and ON automatically for
varying seconds every minute. This cycling is normal and allows you to simmer,
poach, melt or hold cooked food without scorching or burning.
How They Work
•
The burner flame will cycle ON and OFF each minute when the setting is at
any position between LO (past detent) and XLO.
•
The length of time the flame is ON and OFF depends on the knob setting.
•
With a setting just below LO, the flame will be ON approximately 53 seconds
and OFF 7 seconds of each minute.
•
With a setting at the XLO position, the flame is ON approximately 7 seconds
and OFF 53 seconds of each minute.
•
The knob can be set to any position between LO and XLO.
Figure 7 - Extra Low Burner Control Knob
WARNING:
Do not clean or touch any of the burners when one or
both XLO burners are in use. When the XLO burner automatically reig-
nites, the igniter at the burner will spark.
EXTRALOW BURNER CONTROL