Toshiba RD-KX50SU - Manual (Page 25)

25
Connections
Basic Setup
Intr
oduction
Cable box / satellite system
(Keep the power on to receive
commands from the recorder.)
Transmitter
R L VIDEO S-VIDEO
R L IR VIDEO S-VIDEO
CHANNEL
CHANGE
DIGITAL AUDIO
OUTPUT
BITSTREAM/PCM
OPTICAL R L VIDEO S-VIDEO
Y P B P R
INPUT1 COMPONENT OUTPUT
OUTPUT INPUT3
HDMI OUTPUT
1
2
Place as close as possible to the
signal sensor of the set top box.
Connecting the IR control cable
The recorder sends commands to your connected set top box to control the channels of it through the IR control
cable. Follow the instruction below.
1
Connect the plug of the supplied IR control cable to the CHANNEL CHANGE
IR jack on the recorder.
2
Place the transmitter near the set top box connected to the recorder.
After connecting, make the necessary setting ( page 42).
When you use the recorder for the first time, also make the other settings ( page 34).
Notes
• Do not connect an accessory other than the supplied IR control cable to the CHANNEL CHANGE IR jack.
• Do not cover the transmitter.
• The recorder sends commands even while it is turned off.
• Refer to the owner’s manual of the connected set top box as well.
RD-XS52SU/SC_Inst_E_p19-30 04.8.31, 13:03 25