Toshiba RD-KX50SU - Manual (Page 55)

55
Introduction
Connections
Basic Setup
Setting up the remote control
5
While pressing EASY NAVI, press 2.
The remote control mode is set to “DR 2”.
Select the same mode that you have set to the recorder.
Notes
• If the recorder’s mode and the remote control’s mode are different, the recorder’s mode (DR 1, DR 2 or DR 3) appears on the
display of the front panel.
• When the batteries of the remote control are replaced or when the time indicator of the front panel flashes, check the remote
control modes of both the recorder and the remote control, and re-program it if necessary.
Disabling the remote control for a temporary period
You can temporarily disable the reception of the remote control signals at the recorder, when the selection of DR 1,
DR 2 and DR 3 is not sufficient while you are using several Toshiba HDD/DVD video recorders.
Press CH buttons on the recorder at the same time for three seconds or more.
The recorder display shows “DR - OFF”, indicating that the remote control is disabled.
To enable the remote control, perform the same step again. (The display shows “DR-1 , DR-2 or DR-3” depending on
your setting.)
Note
• This function is not available in Standby mode.
• You cannot use this feature when the power is turned off, if you have turned “On” the “Eco. mode” on the menu.
When using with DR 1
mode
When using with DR 2
mode
When using with DR 3
mode
EASY
NAVI
2
D R 1
D R 2
D R 3
D R 1
1
EASY
NAVI +
EASY
NAVI +
EASY
NAVI +
2 D R 2
D R 3
D R 1
3 D R 2
D R 3
Remote control Recorder
Mode setting
PLAY STOP PAUSE
REC
EXTEND
VCR Plus+ REC MENU
CONTENT MENU
EASY
NAVI
TV /VIDEO CH VOLUME CH
MENU
TOP MENU
TV CODE T.SEARCH
RETURN
QUICK MENU
INSTANT SKIP INSTANT REPLAY
DVD
TIMESLIP HDD DVD
FR
AM
E/A
DJU
ST
PIC
TU
RE
SE
AR
C
H
SK
IP
S
LO
W
1 2 3
4 5 6
+ 10
7 8 9
0
ENTER
RD-XS52SU/SC_Inst_E_p48-62 04.8.31, 13:03 55