TRENDnet TEW-P1U1P - Manual (Page 72)

Unix Systems
Your Wireless Print Server supports the LPD Unix printing method, which is supported by all
common Unix systems.
You must configure both the Wireless Print Server itself and your Unix system, as described in
the following sections.
Wireless Print Server IP Address Configuration
Because it supports dynamic IP Address allocation using DHCP or BOOTP, the Wireless Print
Server ships with an IP Address of 0.0.0.0. This is NOT a valid IP Address.
Therefore, you must do ONE of the following:
• Check your DHCP server (if you have one), and determine the IP Address allocated to the
Wireless Print Server.
• Configure your BOOTP Server (if you have one), to provide an IP address to the Wireless
Print Server, then restart the Wireless Print Server.
• Use a Windows platform and run the Setup Wizard or BiAdmin utility to allocate a valid
IP Address to the Wireless Print Server.
• Add an entry to the
arp
table to associate the hardware address of the Wireless Print
Server with the desired IP address, as follows:
arp -s IP_Address 00:c0:02:xx:xx:xx
Where:
IP_Address
is the IP Address you wish to assign to the Wireless Print Server.
00:c0:02:xx:xx:xx
is the hardware address of the Wireless Print Server.
Example
arp -s 192.168.0.21 00:c0:02:12:34:56
You should then assign this IP address to the Wireless Print Server using your Web
Browser, as described in Chapter 6 - Web-based Management.
Note:
The hardware address of the Wireless Print Server is shown on a sticker on the base of the
device.
Other Wireless Print Server Configuration
The recommended method to configure the Wireless Print Server is to use the Web-based
interface, as described in Chapter 6 - Web-based Management.
• Ensure that the TCP/IP settings are correct for your network.
• The logical printers (e.g. L1) must be configured correctly to match your system.
Page 68