Toshiba MA-1595-1 - Manual (Page 167)

6. PROGRAMMING OPERATIONS EO1-11152
6.6 PLU Table Programming (Submode 4)
6-14
NOTES: 1. The “Address Numbers” designation at the top after “3 [X]” can be skipped if not necessary. If
entered, the designated Address(es) will automatically be accessed after the department
designation. For example, if you enter |0204| [#] here (designate each address by entering a two-
digit code; 01 for Address 1, 02 for Address 2, etc.), you will then enter:
[DEPT] key, or Dept Code + [DP#] key,
Character Entries [ST] (“2 [ST]” can be skipped), then
Status Codes [#] (“4 [ST]” can be skipped), then
may go on to another department setting for the same address designations.
But still in this case, you can go to other addresses by first entering the Address No. and
depressing [ST]. The Address Designation feature may be useful when you want to program or
change contents of only one or two specific Addresses of multiple departments. (For example,
when you want to change only the names, but not any other programmed contents, of 15
departments.)
2. The “[DEPT]” key here means each of the individual department keys of Dept Preset-code type.
For example, if you have [DEPT 1] (Department No.1) key, you can depress it, or you may enter 1
then depress [DP#] to start Department No.1 programming procedure. You can only enter the
Dept Code and then depress [DP#] to start any other department than those installed as Dept
Preset-code Keys. When you use a Flat Keyboard and the Setting Mode Key Layout sheet is
inserted, any department may be accessed by using the [DP#] key in the SET mode operations.
Up to 99 departments can be programmed. The [DP#] key should be used to program
departments 61 to 99. (In SFKC programming, up to 60 departments can be programmed.)
3. When the Address No. is sequential from the preceding address (and when the Address
Designation feature has not been used), the Address No. and [ST] may be omitted.
4. The programming contents of each address are further described in the DEPARTMENT TABLE
PROGRAMMING CONTENTS below.
DEPARTMENT TABLE PROGRAMMING CONTENTS
Address No. Description of Programming Contents
1 Linked Group Code
Enter a 4-digit code, composed of a 2-digit Major Group Code and a 2-digit Minor Group
Code.
[#]
Minor Group Code (01 to 30)
Major Group Code (01 to 10)
ex.) To link Major Group No. 1 and Minor Group No. 1:
Enter: (0) 1 0 1
Major Group Minor Group
Code Code
Enter 00 when the department is not
linked to any Minor Group.
Enter 0 (or 00) when the department is
not linked to any Major Group.
Enter 0 for linking neither Major nor Minor Groups (the preceding zeros may be omitted).