Toshiba MA-1595-1 - Manual (Page 226)

3. RESERVATION EO1-11152
3.2 Report Reservation Print Format
3- 3
TABLE OF RESERVATION OPERATIONS (continued)
RTR Declaration: ON
Report Name
Mode
Lock
Key Operation
CUSTOMER FILE REPORTS
(for Check Track Memory type only)
• All Files Read
• All Files Reset
• Zone Files Read
• Zone Files Reset
X
Z
X
Z
615 [AT/TL]
615 [AT/TL]
615 [#] → |Zone-start File Code|
[@/FOR]
→
|Zone-end File Code| [AT/TL]
615 [#] → |Zone-start File Code|
[@/FOR] → |Zone-end File Code| [AT/TL]
NOTES:
1. Reservation function is unavailable when the Satellite Terminals perform the transactions in “SET”,
“X” and “Z” modes.
2. Reservation function is only an operation to copy report data into the communication buffer.
Therefore, actual report cannot be issued by this function. To issue a report, key operation to
issue it is further necessary on the Master Terminal. Refer to the next chapter “4. READ AND
RESET REPORTS” regarding key operation to issue a report.
3. When Reservation operation is performed before the data is set in the communication buffer, “DT
R” will be printed. When the reservation reset is performed under the condition that the reset data
is in the communication buffer, “DT Z” will be printed.
3.2 Report Reservation Print Format
RTR Symbol
Reservation Symbol
Report Name
RTR Symbol
Register No. and Status
OK: Normal status
?: No response
BUSY: The terminal is busy
Blank: Other
statuses
DT_R: Already reserved
DT_Z: Reset data exists
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
08-31-2003 SUN #3001
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
RESERVED
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
#111101 XXXX
#222202 XXXX
#999909 XXXX
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
JONES 0019 12:23TM