Olympus IX81-ZDC2 - Manual (Page 10)

6 7
Application software
} The module names enclosed in are involved in focus drift compensation.
The assembly and adjustments are to be done by Olympus.
Also when the system is going to be transported and reinstalled, consult Olympus.
Warning label
Contact Olympus if this is
peeled off.
NOMENCLATURE
AF sensor unit
Microscope Frame
Class 1 laser
output direction
Stage
IR slider
Provided with the
IX81-ZDC2 system
Focus Handle Interface
U-IFFH
CCD camera
2
Focus Handle
U-FH
AF port switching lever
Pulled-out position: OUT.
Pushed-in position: IN.
Wavelength : 785 [nm]
Beam divergence :
@Objectives attached
0 to 1.49 [NA] *
Depend on objective lens
2Objectives removed
-0.14 to 0.03 [deg]
Depend on offset lens position
Pulse duration : 2.5 [ms]
Pulse repetition rate : 100 [Hz]
Maximum power output : 127.5 [µW]
AF port switching unit
PC
Use a system meeting the
IEC60950 requirements.
Control board
Control Box
IX2-UCB
Hand Switch
U-HSTR2
· I2-ZDC2PCB
This board can be
used only with a
ZDC2-dedicated
microscope frame
(IX81F-ZDC2 or
IX81S1F-ZDC2).