Figure 3. lcd control panel – Teac DVW-D110H User Manual

Page 12

Advertising
background image

Front Panel

4

TEAC 1x10 DVD Duplicator User’s Manual

LCD control panel:

Use the control panel buttons to navigate through the

various functions viewed on the LCD display.

Figure 3. LCD Control Panel

The DVD Duplicator control panel features an LCD display and two buttons.
These buttons are described in the following table:

target drives:

Insert a blank disc into each target drive to make a copy of the

source disc. You can open the tray by pressing the eject button (if the tray fails
to open, you can use the emergency eject mechanism). You can close the tray
by pressing the eject button.

LED power indicator:

The LED power indicator will be continuously lit

when the DVD Duplicator power is on

.

power switch:

Use the power switch to turn the power to the DVD Duplicator

unit on and off.

stabilizing feet:

A stabilizing support foot is located at each of the DVD

Duplicator’s lower four corners. When you set up the Duplicator, you should
extend each of these feet outward to provide stable support for the unit.

In Operation mode, press the SET button to scroll up through the functions
or menus.

In Operation mode, press the RUN button to execute the selected function.

Note:

TEAC strongly recommends that you do not push the tray in to close

it. Please press the eject button to eject or retract the tray.

Advertising