Teac DVW-D110H User Manual

Page 17

Advertising
background image

Loading Data to and Copying from the Hard Disk Source Drive

TEAC 1x10 DVD Duplicator User’s Manual

9

Loading Data to and Copying from the Hard Disk Source Drive

During initialization (see Step 4 on page 7), the DVD Duplicator performs a self-
test to detect source drives. The DVD-ROM drive and hard disk drive will be
detected as available source drives. The DVD-ROM drive is the default source
drive.

The internal hard disk drive was formatted and partitioned at the factory. Each
partition occupies 9GB of hard disk space. Partitions are arranged in numerical
order starting with partition 00000, and initially contain no data. A set of data
loaded into a partition on the hard disk drive is called an “image file.”

To use the hard disk drive as the source drive, you must first load an image file
from a DVD into a partition on the hard disk drive, select the partition that
contains the data you want to copy, then execute the copy function.

1.

Insert a source DVD into the DVD-ROM drive.

This disc contains the data that you wish to copy to the partition on the
internal hard disk drive.

2.

Press the SET button to select the

Load

function, then press the RUN

button to execute the function.

The data will be loaded into the default first partition (00000).

After a few moments, the source disc will be ejected, signaling the
completion of the data load procedure.

3.

Remove the source disc from the DVD-ROM drive.

4.

Once the data has been copied to the hard disk drive, insert a blank disc
into as many of the target drives as you desire.

5.

Using the SET button, change to the

Copy

function, then press RUN to

copy from the hard disk drive to the discs.

The discs will be ejected when the copying process is complete.

6.

Remove the copied discs from the Duplicator.

You can repeat this procedure from Step 4 if desired.

Note:

If you need to load additional data from various sources, change to

another partition first (e.g., 00001) using the

Partition Name

function in

Setup

mode, then repeat steps 1 and 2 above.

Advertising