Thermador DM301 - Manual (Page 56)

Built-in DM Oven Care and Use Manual
54
Do-It-Yourself Maintenance
Do-It-Yourself Maintenance
Fahrenheit to Celsius
The oven has been preset to a Fahrenheit temperature.
To change to Celsius, follow these steps:
I.
Turn off ovens.
2. Touch and hold the START pad and then the CONVECTION pad
at the same time for 3 seconds.
3. “F” appears in the temperature digits; release both pads at the
same time.
4. Touch CONVECTION; “C” replaces “F.” This alternates when
CONVECTION is touched.
5. To complete the change, touch START.
Calibrating Oven Temperature
The electronic thermostat has been preset to 0°F and accurately
maintains its setting. If the browning results are too light or too dark
for your preferences, you can raise or lower the setting.
To change calibration of oven temperature for single or
upper ovens:
1.
Turn off oven(s).
2. For single oven or upper oven, touch and hold the START pad
and then touch the BAKE pad.
3. “0” (zero) appears in the temperature digits; release all pads at
the same time.
4. Touch BAKE and 0 changes in increments of 5 degrees each
time it is touched. The maximum adjustment is ± 35ºF.
5. To complete the change, touch START.
To change calibration of oven temperature for lower oven on
double ovens:
1.
Touch the ROAST pad.
2. Continue with Steps 3 through 5, as described above.
NOTE: The available temperature range for this oven is
100ºF to 550ºF. This applies to all conventional
cooking modes. A change in the calibration does
not affect Dehydrate, Proof or Warm modes.
Voltage Change Option
The oven has been preset for 240 VAC. If your residence has been
supplied with 208 VAC, the oven voltage can be changed during
installation.
1.
Turn both ovens off. Touch OVEN OFF for each oven.
2. Touch and hold the START pad and the SELF CLEAN pad at the
same time for 3 seconds.
3. “240” appears in the display. Release both pads at the same
time.
4. Touch the SELF CLEAN pad. “240” is replaced with “208.” This
alternates when SELF CLEAN is touched.
5. To complete the change, touch START.
For authorized service or parts information, phone (800) 735-4328.
We want you to remain a satisfied customer. If a problem occurs that cannot be resolved to your
satisfaction write to Thermador Customer Support Center,
5551 McFadden Avenue, Huntington Beach CA, 92649 or call: 1-800-735-4328.
Please include the Model Number, Serial Number, Fabrication Date and Date of Original Purchase and
Installation.
How to Obtain Service
Beep Volume
The volume of the beeps can be adjusted. Touch and hold the START
pad followed by the PROBE pad for three seconds. Touch PROBE
pad again to increase or decrease volume, from levels 1 to 3. Touch
START to set volume selection.