Topcom MIRA 200 - Manual (Page 5)

Mira 200 Mira 200
9
5. GENERAL
With cordless telephones, radio connection replaces the cord connecting the
handset to the base unit of traditional telephones. This allows you to make and
receive calls even when you are away from the base unit. Thanks to this radio
connection, your mobility increases.
The Mira 200 has a working range of 300 m (range is reduced to 60 m inside
buildings). This working range is however strongly reduced if there are several
obstacles between the base and the handset. If you have gone too far away from
the base, you will hear a warning signal.
6. INST A L L A TION
1. Connect the telephone cord to the left socket on the rear of the base (rear of
base facing you) and plug the other end into the telephone line wall socket.
2. Connect the power cable plug to the power socket with indication “AC9V” on
the right side of the rear of the base (rear of base facing you) and plug the
adaptor into a power socket.
3. To avoid messages from being erased during a power failure, put the 9V back-
up battery in the compartment on the bottom of the base station. If this bat-
tery is not placed, ‘LO’ (low) appears on the display.
4. Adjust the antenna located on the left side of the base to a straight upward
position.
Remove the transparent plastic protection of the telephone number card on the
base station by pushing it to the left. Write down your own telephone number on
this card and put the plastic protection back.
8
4. BASE STATION
4.1. TOP VIEW
1. Speaker
2. Display
3. Battery indicator
4. Radio connection indicator
5. Indicator OGM 2
6. Program indicator
7. Program button; on/off
8. Recording button OGM 2/ERASE
9. Recording button OGM 1
10. STOP button
11. Playback/Fast forward button
12. Rewind/Memo button
13. Paging button
14. Microphone
15. Indicator OGM 1
16. Power indicator
17. Antenna
4.2. REAR VIEW
1. Connection telephone line
2. Connection adaptor
4.3. SIDE VIEW
1. Volume switch
2. Ringer volume switch
3
4