Topcom MIRA 200 - Manual (Page 8)

Mira 200 Mira 200
15
8.10.2. DIALLING A MEMORY NUMBER
1. Press the line button and wait for the dial tone.
2. Press the memory button (“SPEED DIAL” appears on the display).
3. Press the number of the memory place, where the telephone number has been
stored (0-9). The telephone number is now automatically dialled.
8.10.3. SEARCHING A MEMORY NUMBER
1. Press the line button and wait for the dial tone.
2. Press the memory button (“SPEED DIAL” appears on the display).
3. Press the button to see the following number or the # button to see the
previous number.
You can dial a memory number while going through the memory numbers by
pressing the redial button
when the desired number appears on the display.
8.10.4. ERASING A MEMORY NUMBER
1. Press the line button and wait for the dial tone.
2. Press the set button (“SET” appears on the display).
3. Press the memory button (“PHONE NO-” appears on the display).
4. Press the number of the memory place (0-9) of the memory number you wish
to erase.
5. Press the set button (“DONE” appears on the display).
6. Press the line button to stop the radio connection.
8.11. CALL BARRING
The numerical buttons of the Mira 200 can be locked electronically so that out-
going calls are not possible any more.
14
8.9. TEMPORARY PULSE -> TONE SWITCH
The Mira 200 has been preset to pulse dialling. It is however possible to switch
temporarily to tone dialling f.i. for telebanking, pager calls, ...
You can use this function by pressing the
button immediately after having
dialed the desired telephone number. Now you can enter the desired numbers in
tone dialling mode.
After pressing the line button or the hang-up button your Mira 200
automatically returns to pulse dialling.
8.10. DIALLING MEMORY NUMBERS
The Mira 200 disposes of 10 memory numbers (speed dial numbers). Each
memory place can store a telephone number of maximum 16 digits. You can call
a memory number by pressing the memory button
followed by the num-
ber of the memory place where the desired telephone number has been stored
(0-9).
8.10.1. STORING MEMORY NUMBERS
1. Press the line button and wait for the dial tone.
2. Press the set button (“SET” appears on the display).
3. Press the memory button (“PHONE NO-” appears on the display).
4. Choose a memory place by pressing a numerical button (0-9).
5. Enter the telephone number that you wish to store.
6. Press the set button (“DONE” appears on the display).
7. Press the line button to stop the radio connection.
You can also program a flash or pause in the memory numbers. During the pro-
gramming of the memory numbers press the R -button for a line interruption or
the redial button
for a pause. In order to set the pause time, see 8.13. Setting
pause time.