Toshiba P100/P105 - Manual (Page 59)

59 Getting Started
Adding memory (optional)
5.375 x 8.375 ver 2.3
18 Restart the computer.
TECHNICAL NOTE: You must have at least one memory
module installed for the computer to work.
You can now continue setting up the computer. When the
operating system has loaded, you can verify that the
computer has recognized the additional memory module.
If you are adding an extra memory module after setting up the
computer, verify that the computer has recognized it correctly
as described in
“Checking total memory” on page 61 .
Removing a memory module
If you need to remove a memory module:
1 Complete steps 1 – 8 in “Installing a memory module” on
page 54 to shut down the computer and open the memory
module slot cover.
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the memory
module.
Do not remove the memory module while the computer
is in Standby or Hibernation mode. The computer could
hang up the next time you turn it on and data in memory
will be lost. In either of the above cases, the Standby
configuration will not be saved.
The following message appears when you turn on the
power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.