Teac HD-1 - Manual (Page 10)

10
The HD-1comes mounted with an adapter for iPod with “iPod
classic(160G)+iPhone 2G/3G”. To play your iPod through the
HD-1, you have first to check if the factory mounted adapter fits
your model of iPod. If it does not, you have to replace it with a
correct one, as explained below.
1 Remove the adapter from the Dock of the HD-1.
Hold the left and right sides of the adapter and gently pull it
up.
2 This unit includes dock adapters as follows:
“nano” for iPod nano 1st and 2nd generations.
“60GB (color) + Photo 40GB/60GB” for iPod with
Click Wheel (40 GB), iPod with color display.
“20GB + U2” for iPod with Click Wheel
(20 GB, U2 Special Edition).
iPod classic (160G) + iPhone 2G/3G ( Premounted )
< Use a commercially available adapter or a supplied one
with your iPod to play other iPods.
3 Insert the adapter into the Dock of the HD-1.
Fit the front edge of the adapter into the Dock, and then
press the back edge of the adapter onto the Dock until
a slight “click” is heard indicating the adapter is inserted
correctly.
Compatible iPod Software
In case your iPod will not work with the HD-1or with the remote
control unit, software update may solve the problem.
Visit the Apple website and download the latest iPod Software.
http://www.apple.com/uk/ipod/download/
“Made for iPod” means that an electronic accessory has been
designed to connect specifically to iPod and has been certified by
the developer to meet Apple performance standards.
“Works with iPhone” means that an electronic accessory has
been designed to connect specifically to iPhone and has been
certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
Getting started
1
2
Power Source
• This HD Radio Receiver operates from AC120V/60Hz line
power supply.
• The Remote Control operates on 1 Lithium battery, CR2032
(Included).
Insert the AC plug into a standard 120V AC outlet . The Radio
will automatically go into standby mode.
NOTE :
The system has an AC plug and will only fit into matching
AC outlets. This is a safety feature to reduce the possibility
of electric shock. If the plug will not fit in your AC outlets,
you should have the outlet changed by a qualified, licensed
electrician. Do not use an adapter to make the plug fit into
your outlet. This defeats the safety feature and could expose
you to electric shock.
Protect your Furniture
This model is equipped with non-skid rubber 'feet' to prevent
the product from moving when you operate the controls.
These 'feet' are made from non-migrating rubber material
specially formulated to avoid leaving any marks or stains on
your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause the
rubber 'feet' to soften, and leave marks or a rubber residue
on the furniture. To prevent any damage to your furniture we
strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement
centers everywhere, and apply these pads to the bottom of
the rubber 'feet' before you place the product on fine wooden
furniture.