Teac HD-1 - Manual (Page 6)


Connection
A AC Power Cord
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.
B Phones jack
For private listening, first reduce the volume level to
minimum. Then insert the plug from your headphones into
the PHONES jack, and adjust the volume using the VOLUME
knob. The sound from the speakers is cut off while the
headphone jack is inserted.
CAUTION
Always lower the volume level prior to plugging in your
headphones. TO AVOID DAMAGING YOUR HEARING - Do
not place your headphones on your head until after you
have plugged them in.
C Line out jack
You can connect this unit to an external amplifier, Connect
the pin cords. Make sure to connect to MINI PLUG JACK.
NOTE :
< This output jack is a “line level” output. Do NOT connect
to the “PHONO” jack on your amplifier or distortion may
occur.
< The volume level of line output cannot be adjusted by the
VOLUME control knob of this unit. Use the volume control
of your amplifier to adjust the volume.
D AUX IN jack
You can connect a portable audio player to this jack.
Connect the LINE OUT or PHONES jack (audio output jack)
of the player using the supplied stereo mini plug cable.
When using the PHONES jack of your mini player, you must
adjust the volume of the mini-player or you may hear no
sound from your HD-1.
E VIDEO OUT jack
This terminal outputs video signal from iPod.
Use an RCA (pin) video cable to connect the Dock to the
composite video connector of a television or monitor.
F AM loop antenna connector
Connect the supplied AM loop antenna to the
AM ANTENNA connector.
Place the antenna in the direction which gives the
best reception.
G FM antenna jack
While in FM mode, tune in an FM station and
extend the lead to find the best position for the
reception. This antenna may need to be
repositioned if you move your unit to a new
location
.
H Battery compartment
The battery supplies a backup power to the builtin clock and
preset, when the unit is momentarily disconnected from the
AC outlet.
1. Remove the lid.
2.Insert two AAA batteries.
3. Replace the lid.
Battery replacement
If the clock comes to indicate the wrong time,
replace the battery with a new one.
Precautions concerning AAA/UM-3 battery
< Be sure to insert the battery with correct positive
“+” and negative “_” polarities. >
< Do not heat or disassemble battery and never
dispose of old battery by throwing them in a fire. >
PHONES LINE OUT AUX IN VIDEO OUT AM-ANTENNA-FM 75Ω
NOTE :
< The battery should be removed when not using it in a long
term.
< The battery must use an alkaline battery on the market.