Teac HD-1 - Manual (Page 17)

ENGLISH
1
DIMMER function
You can change the front panel’s display brightness. Use the
DIMMER button to change the brightness among 4 levels.
You can change display brightness by using DIMMEN botton.
How to use the snooze function
After the ON time is reached, press the SNOOZE button and
the unit will turn off for 6 minutes then turn on again.
You can use this function repeatedly during 1 hour alarm
cycle.
Snooze/Dimmer Operation
1 Set the alarm time per Setting Alarm time. To preview the
alarm time, just press the ALARM 1 button or ALARM 2
button to turn on the Alarm function.
2 Press the ALARM 1 button or ALARM 2 button again to
arm or disarm the alarm.
3 When the alarm is sounding, press the * STANDBY/ON
button to turn the Alarm OFF. The alarm will come on again
the next day at the same time.
*: SLEEP
*: iPod/iPhone connecting
*: Press the ALARM 1 button
*: Press the ALARM 2 button
4 To stop the alarm from coming on the following day, press
the ALARM 1 button or ALARM 2 button to turn it OFF. The
Alarm Icon will disappear to indicate the alarm is disarmed.
• If the alarm is not turned off after it sounds it will play for
approximately 1 hour then turn off automatically. This cycle
will repeat every 24 hours unless the controls are changed.
NOTE :
• When setting the unit to “Wake to iPod,” Your iPod must be
properly docked and turned off or the alarm will not sound.
• When you select “Wake To iPod,” be sure your iPod has
enough songs to play for 1 hour, otherwise set the iPod
repeat mode to ON. If there is no iPod is present or there
is no music on your iPod at alarm time, the HD-1 will
automatically switch to buzzer alarm.
• Alarm function is still working at the Standby ON mode.
• Playback volume will gradually increase up to your set
volume when the unit is turned on by Alarm.
ALARM 1
ALARM 2
1
2
Using the Alarm